You are browsing documentation for a version other than the latest stable release. Switch to the latest stable release, 1.5.

Raw flash

This chapter introduces the technical details of raw flash support in Mender.


Support for raw flash memory under Linux is in general more complicated than working with block devices. It is advised to have a fully working bootloader, kernel and rootfs before introducing Mender.

The Mender Yocto layer comes with support for the following raw flash boards in the main tree:

  • Toradex Colibri VF50/VF61 meta-mender-toradex-nxp
  • vexpress-a9 emulated by QEMU meta-mender-qemu

Both layers provide a set of patches based on their respective upstream U-Boot sources and can be used as a reference when implementing your raw flash based machine.

As an example, to illustrate potential pain points we will use a Versatile Express CortexA9x4 board, emulated under QEMU (vexpress-a9 target). See the next example section.

Raw flash storage

The Mender Yocto layer comes with support for auto-configuring most aspects of the Flash specific components, including partitioning and the U-Boot bootloader. But there is at least one piece of information that must be supplied: The MTDID string, which describes the Flash type and the location it has in the device's memory. For example:

MENDER_MTDIDS = "nor0=40000000.flash"

Having one entry will allow the Mender Yocto layer to deduce the proper storage parameters and partition layout. If the device has more than one unit of Flash storage, it is possible to add more than one entry, separated by comma; in this case you will also need to set MENDER_IS_ON_MTDID to the Flash device that you want Mender to reside on and update. For example:

MENDER_MTDIDS = "nand0=40000000.flash,nand1=60000000.flash"
MENDER_IS_ON_MTDID = "60000000.flash"

Note that currently Mender only supports running on, and updating, one Flash storage device, but you can have more Flash storage devices inside one system outside of Mender's control.

Please refer to the documentation for your device to find out what value to put in MENDER_MTDIDS. If in doubt, a good place to look is the U-Boot source code for the board, specifically the value of CONFIG_MTDIDS_DEFAULT.

For more information about variables that affect a Flash build, see the Variables section.

Image types

There are three relevant image types that can be built when using raw flash. They can be enabled by adding them to the IMAGE_FSTYPES Yocto variable.


A UBI filesystem that contains the root filesystem. The data filesystem is also built using the same filesystem type.


A UBI image that contains multiple UBI volumes, at minimum including two root filesystem volumes and one data volume. It will also normally contain two volumes to store two redundant copies of U-Boot's environment data.

This image can be flashed to an MTD device into its "ubi" partition, as identified from its "mtdparts" string (MENDER_MTDPARTS).


A raw flash image for MTD devices that contains the ubimg as well as other components specified in the MENDER_MTDPARTS variable.

This image can be flashed directly to a raw Flash device.