Be careful when running
apt upgrade on a device with Mender Operating System updates enabled. Integration
apt upgrade (through the
grub.d framework) is only implemented for x86 as of
mender-convert version 4.0.2. For ARM and other non-x86 architectures, always update single
applications only, because running
apt upgrade may brick your device!. If you need to run
apt upgrade, do it on a pristine system without Mender installed, and then convert it to a Mender
afterwards. We may lift this restriction in the future.
Below are a number of general requirements for using Mender.
The client binaries are about 7 MB in size, or about 4 MB when debug symbols are
stripped (using the
strip tool). This includes most of the dependencies for
the client, such as the http, TLS, and JSON libraries.
The client depends on the LZMA library for Artifact compression, which is present in most Linux distributions, including those based on the Debian family.
To support atomic rootfs rollback, Mender integrates with the bootloader of the device. Currently Mender supports GRUB and U-Boot. Some boards may require a board integration; visit Mender Hub to find board integrations that community members have submitted. If no board integration is available for your board, we recommend you try it without any integration, as GRUB may work without additional configuration on both ARM and x86.
In order to support robust rollback, Mender requires the device to have a certain partition layout. You need at least four different partitions:
One of the rootfs and kernel partitions will be the active partition, from which the kernel and rootfs will boot. The other, called the inactive partition, will be used by the update mechanism to write the updated image. After an update they switch roles.
The persistent data partition stores data that must persist through an update.
Below is a sample partition layout:
Certificate verification requires the device clock to be running correctly at all times. Make sure to either have a reliable clock or use network time synchronization. Note that the default setup of systemd will use network time synchronization to maintain the clock in a running system. This may take a few minutes to stabilize on system boot so it is possible to have a few connection rejections from the server until this process is complete and the time is correct. Please see certificate troubleshooting for more information about the symptoms of this issue.
If your device does not have an active internet connection, then systemd will be unable to configure the system time as it will be unable to connect to the network time servers. In this case you will need to arrange other methods to set a proper system time. Many standard Linux features can be used for this. If your system includes a real-time clock chip, that will maintain the time across power down situations and the network connectivity needs of systemd will only be relevant on the system boots before the RTC is properly initialized.
Before the time is set properly, either by systemd or the RTC, the time will default to the Unix Epoch. Note that the Mender Server will reject client connections until this situation is resolved.
Mender has official support for the Yocto Project build system and binary OS images based on the Debian family. It is possible to adapt to other build systems. Please see this community post for a concrete description.
For help from the community, as well as links to board integrations, visit Mender Hub.
© 2023 Northern.tech AS